User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
DOC-13000 Rev. E 7–33
Connex500/350 User Guide
Thefirstinaseriesofalignmentscreensappears.
Figure 7-45: Head alignment screen
11. Inthehead‐alignmentscreen,selectthenumberthatindicateswhich
linesalignintheupperandlowerrowsofapaironthetransparency
(countingfromtheleft)forthisprinthead.
Note: Because the alignment of the fourth lines is optimum, the number “4”
is selected, by default, in the wizard screen. This does not change the head
alignment. If you select other numbers, the wizard adjusts the head
alignment, accordingly.
12. ClickNexttodisplaythenextheadalignmentscreen,andagainselect
thenumberrepresentingthemostcloselyalignedverticallinesonthe
transparencyforthatprinthead.
Whenyouhavefinishedaligningalloftheheads,thefollowingscreen
isdisplayed.
Figure 7-46: Updating System Parameters confirmation screen
13. Continueasfollows:
• Tomakethealignmentchangesintheprinter,makesurethatYesis
selected,andclick
Next.
• Torecheckthealignmenttestresultsbeforemakingthealignment
changesintheprinter,click
Previous.
• Ifyoudonotwanttomakealignmentchangesintheprinteratthis
time,selectNoandclick
Next.