User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
Operating & Maintaining the Connex500/350 3-D Printer
7–14
DOC-13000 Rev. E
9. ClickNext,andtakenoteofthewarningscreen.
Figure 7-13: Material Replacement warning screen
10. Tocontinue,clickNext.
11. Whenprompted,loadthenewcartridge(s).Confirmthisinthewizard
screenandclick
Next.
Figure 7-14: Prompt to load new model cartridges
Afteridentifyingthenewcartridge(s),theConnexprinterbeginsfilling
theprintheadswiththenewmodelmaterial.
Figure 7-15: Material replacement: filling heads with new material
Once you start this procedure, you must complete it before you can produce
models with the Connex printer. To perform the procedure at another time,
click Cancel. If you continue (by clicking Next) and you do not complete the
procedure, you must start the Material Replacement wizard again before
producing models.