User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
DOC-13000 Rev. E 7–11
Connex500/350 User Guide
4. IntheCompartmentSelectionscreen,selectthecartridge(s)youwantto
replace,andclick
Next.
Figure 7-9: Compartment Selection screen
5. Fromthedrop‐downmenu,choosethemodelmaterialyouwantto
install,andclick
Next.
Figure 7-10: Material Selection screen
Note: This selection automatically affects the default material settings in
Objet Studio.
6. TheMaterialReplacementWizardcontinuesasfollows:
• If,accordingtoyourselectionsinthepreviouswizardscreens,you
arereplacingbothmodelmaterialcartridges,andtheprinterwillbe
loadedwithtwocartridgescontainingthesamemodelmaterial,the
Connexprinterflushestheentiresystem,andpreparesforprinting
inSingle‐Materialmode(seebelow).Continuewithstep8on
pag
e 7‐13.
• If,accordingtoyourselectionsinthepreviouswizardscreens,you
arereplacingbothmodelmaterialcartridges,andtheprinterwillbe
loadedwithtwodifferentmodelmaterials,theConnexprinter
flushestheentiresystem,andpreparesforprintinginDigital‐
Materialmode(seebelow).Continuewithstep8onpage 7‐13
.
• If,accordingtoyourselectionsinthepreviouswizardscreens,you
arereplacingonlyoneofthemodel‐materialcartridges,andthe