User's Manual

Installing Objet Software
4–2 DOC-13000 Rev. E
How to Install Software for the Connex 3-D Printing System
TheObjetStudiosetupwizardguidesyouwheninstallingtheObjet
software.Duringinstallation,youmustchoosetoinstalleithertheserver
(“host”)applicationortheclientapplication.
To install Objet software:
1. InserttheObjetStudioCDintothediskdrive.
2. Right‐clickthe
StartbuttonandselectExplore(oruseanyothermethod
fordisplayingfilesonthecomputer).
3. OpentheCD‐drivefolderandselectSetup.
Toruntheinstallationwizard,youmustaccepttheObjetStudiolicense
agreement.Afterreadingitsterms,click
Yestocontinue,orNotoclose
thewizard.
IfyouclickYes,thefollowingscreenshouldappear.
Figure 4-1:Objet Setup—installation wizard Welcome screen