User's Manual

DOC-07000 Rev. A 5–61
Objet500 - Connex 3 User Guide
Setting the
Printer
Connection
WhenanObjet3‐Dprinterisinstalled,theservercomputerisconnectedto
thatprinter.Normally, thereshouldbenoreasontochangethisconnection.
Occasionally,however,youmayneedtoresettheconnection,toconnect
theservertoanotherprinter,ortouseObjetStudioinoff‐linemode

(withoutaprinterconnection).
To set (or change) the printer connection:
1. OntheJobManagerribbon,inthe3DPrintergroup,click.
2. IntheSetPrinterdialogbox,click
Connect.
3. EnterthecomputernameoritsIPaddress,orclick
Browsetofindand
selectit.
4. ClickOK.
Whentheconnectionisestablished,ObjetStudioisconfiguredto
prepareprintjobsforthatprinter.
Objet Studio is connected to the printer if you can see the material levels in
the Job Manager screen.