User's Manual

DOC-07000 Rev. A 5–29
Objet500 - Connex 3 User Guide
Measurement
Units
3‐Dfilescontainanobjectʹsproportions,butnotitsunitsofmeasure.
Therefore,makesuretocorrectlyselecteithermillimetersorincheswhen
insertinganobject.Otherwise,thesizeoftheobjectonthebuildtraywillbe
eithermuchtoolargeormuchtoosmall.
Tosetthemeasurementunitswheninsertinganobject:
¾
IntheInsertdialogbox,Unitsfield,selectMillimeterorInch:
TochangeunitsofmeasurementontheModelSettingsribbon:
1. OpentheUnitsflyouttoolbar.
Figure 5-23: Units flyout toolbar
2. Selectthemeasurementunitsdesired.
To change units of measurement with the Standard Toolbar:
1. FromtheObjectmenu,selectChange Units.
Figure 5-24: Model Units dialog box
2. IntheModelUnitsdialogbox,changethesettingandclickOK.