User's Manual
DOC-07000 Rev. A 5–27
Objet500 - Connex 3 User Guide
2. SelectDynamic checktoidentify:
• invalidobjectplacementwhileplacingobjects—OnDropselected.
• invalidobjectplacementaftermovingobjects—WhileDragselected.
• objectsplacedbeyondthetray’sboundaries—OutsideTrayselected.
• objectsthatoverlap—ObjectCollisionselected.
Note: Remember that Objet Studio calculates the space occupied by an
object including the “bounding box” surrounding it (see figure 5-40
on page 44).
Even if you do not use Dynamic Check when placing objects on the build
tray, Objet Studio automatically checks if there is a problem with the
positioning of objects on the tray before sending it to the printer. You can
also manually check for problems after positioning objects.