User's Manual

DOC-07000 Rev. A 5–9
Objet500 - Connex 3 User Guide
Figure 5-7: Assembly check box selected—stl files are placed as an assembly
Figure 5-8: Assembly check box not selected—stl files are placed as parts
TheModelSettingsribbonisdisplayedwhenobjectsareplacedonthe
buildtray.
5. Selectanyofthefollowingoptions,asrequired:
• Units—Millimetersorinchesfortheobject’sunitsofmeasure.
The3‐Dfilecontainstheobjectʹsproportions,butnotitsunitsof
measure.Therefore,makesuretocorrectlyselecteither
millimeters
or
incheswheninsertinganobject.Otherwise,thesizeoftheobject
onthebuildtraywillbeeithermuchtoolarge ormuchtoosmall.To
changethemeasurementunitsofobjectsalreadyplacedonthetray,
see“MeasurementUnits”onpage 36.
• Number of copies—Howmanycopiesofthisobjecttoplaceonthe
buildtray.
• Orient Automatically—Automaticallyorientobjectsonthebuild
trayforefficientmodelbuilding.
• Assembly—Markthischeckboxifyouselectedmultiplestlfiles
thatarepartofanassembly.