User's Manual
DOC-07000 Rev. A 6–47
Objet500 - Connex 3 User Guide
To prepare a new waste container:
1. Assemblethecardboardbox,makingsuretopunchouttheperforated
sections.
2. Placeanewplasticcontainerintothebox.
Note: Do not close the box until you connect the waste drain tube from the
printer (see below).
To replace the waste container:
Locatethedooronthelower‐leftsideoftheprinter.Pushintheupper‐
rightcornerofthedoortoreleasethelatchandopenthe
door.
Figure 6-61: Accessing the waste container
3. Carefullyslideoutthewastecontainertoremoveitfromtheprinter.
Figure 6-62: Removing the waste container
4. Placethenewwastecontainernexttothefullcontainer.
5. Unscrewthecapsecuringthewastedraintubeandconnectittothe
newcontainer.
6. Closethefullcontainerwithasealingcap.
7. Closethenewwaste‐containerbox,usingtapetoholditclosed.
8. Positionthewastecontainerundertheprinter,
ontheloadcells.
• Thecontainershouldbeontheextremerightsideofthe
compartment.
• Makesurethatthewastedraintubeisnotcrimpedandthatitisnot
pinchedbythecontainer.