User's Manual

DOC-07000 Rev. A 6–43
Objet500 - Connex 3 User Guide
Test List TestName
Thiscolumnlistsallofthetests,togetherwithselectioncheckboxes.
Clickthecheckboxestoselectthetestsyouwanttorun.Toremovea
selection,clickthecheckboxagain.Toquicklyselectallofthetestsina
componentcategory,usetheGrouppull‐downmenuat
thebottomofthe
screen.
Group
Thiscolumnshowsthecomponentcategoriesforeachtest.
ThistellsyouwhichtestsarerunwhenselectingacategoryfromtheGroup
pull‐downmenuatthebottomofthescreen.
Status
Thiscolumnshowsthestatusofeachtestafteryourunit:
Test Selection Area IntheTestSelectionarea,atthebottomofthescreen,youcanquicklyselect
orde‐selecttestsbytheircharacteristics:
Running Tests
To run the selected tests:
¾
Click .
Test Results
To save and view a report of all of the tests:
¾
UsetheSaveandViewcommandbuttons(seebelow).
Testsuccessfullycompleted.
Testfailed.
Unknownresults.(Thetesthasnotbeenrunyet.)
All
Clicktosel ectallofthetestsinthelist.
None
Clicktode‐selectallofthetestsinthelist.
Unknown
Clicktosel ectalltestthathavenotbeenrunyet(Status = ?).
Group
Usethismenutoselecttestsbycomponentcategory.
Selection
Set
Usethismenutoselectapre‐configuredsetofteststorunat
specifiedtimes(computerstartup,beforeprinting,etc.).
After you run a test, the Save and View command buttons are added to the
Built In Tests screen (see below).