User's Manual

Operating & Maintaining the Objet500 - Connex 3 3D Printer
6–36 DOC-07000 Rev. A
adjusttheireffectivepowerwiththeUVCalibrationWizard(see“Testing
andCalibratingtheUVLamps”onpage 190.IfyouneedtoreplaceaUV
lamp,followtheseinstructions:
1. Makesuretheprinterisinofflinemode.
Figure 6-46: Offline mode indicator (red)
Theonline/offlinebuttonatthebottomoftheprinterinterfaceshouldbe
red.Ifnot,clickittoswitchtheprintertoofflinemode.
2. StarttheUVLampReplacementWizard.
• FromtheOptionsmenuoftheprinterinterface(seefigure 6‐33on
page 6‐27),select
Wizards > UV Lamp Replacement.
3. Makesurethatthebuildtrayisempty,andconfirmthisinthewizard
screen.Then,closetheprintercoverandclick
Next.
Figure 6-47: “Empty tray” confirmation screen
Theaxesmovetothe“home”position.
4. SelecttheUVlamp(s)tobereplacedandclick
Next.
Figure 6-48: UV lamp selection screen
WARNING: Before continuing, make sure that the safety interlock in the
printer cover is not defeated, and that the lamp is not hot.