User's Manual

DOC-07000 Rev. A 6–33
Objet500 - Connex 3 User Guide
Thefirstinaseriesofalignmentscreensappears.
Figure 6-41: Head alignment screen
11. Inthehead‐alignmentscreen,selectthenumberthatindicateswhich
linesalignintheupperandlowerrowsofapaironthetransparency
(countingfromtheleft)forthisprinthead.
Note: Because the alignment of the fourth lines is optimum, the number “4”
is selected, by default, in the wizard screen. This does not change the head
alignment. If you select other numbers, the wizard adjusts the head
alignment, accordingly.
12. ClickNexttodisplaythenextheadalignmentscreen,andagainselect
thenumberrepresentingthemostcloselyalignedverticallinesonthe
transparencyforthatprinthead.
Whenyouhavefinishedaligningalloftheheads,thefollowingscreen
isdisplayed.
Figure 6-42: Update confirmation screen
13. Continueasfollows:
• Tomakethealignmentchangesintheprinter,makesurethatYesis
selected,andclick
Next.
• Torecheckthealignmenttestresultsbeforemakingthealignment
changesintheprinter, click
Previous.
• Ifyoudonotwanttomakealignmentchangesintheprinteratthis
time,selectNoandclick
Next.