User's Manual
DOC-07000 Rev. A 6–31
Objet500 - Connex 3 User Guide
To check the alignment of the print heads:
1. Prepare—
• atransparencysheet—A‐4orLettersize
• anytypeofstickytape,tofastenthetransparencysheettothebuild
tray
2. StarttheHeadAlignmentWizardfromtheOptionsmenu(see
figure 6‐22onpage 6‐22).
3. Click
Nexttobegin,andclosethecover.
4. Inthewizardscreen,selectthecheckboxtoconfirmthatthecoveris
closed,andclickNext.
5. Wheninstructedtodoso,placethetransparencyonthebuildtray—
nexttotheleftandrearedgesofthetray,asshowninthefollowing
figure.
Figure 6-37: Positioning the transparency on the build tray
6. Makesurethatthetransparencysheetislyingflat,andtapeittothe
tray.
7. Inthewizardscreen,selectthecheckboxtoconfirmthatthe
transparencysheetisonthebuildtray,andclick
Next.
Theprinterprintstheheadalignmenttestonthetransparency.
8. Whenthefollowingscreenappears,removethetransparency.
Figure 6-38: Head Alignment Wizard—steps 8–10