User's Manual

Operating & Maintaining the Objet500 - Connex 3 3D Printer
6–26 DOC-07000 Rev. A
3. RemovetherightUV‐lampassembly:
a. DisconnecttheUVpowercableandthefanpowercable.
Figure 6-26: Disconnecting the right UV assembly
b. RemovethescrewattachingtherightUVlamptotheprintblock,
andthenpullandliftuptheUVlamp.
4. Loosenthetwoscrewssecuringthesuctiontubeontheprintblock.
Figure 6-27: Lifting the suction tube
5. Liftthesuctiontubetosecureitinaraisedposition.
Fan power
connector
Power connector
Screw
Suction tube screws