User's Manual

Operating & Maintaining the Objet500 - Connex 3 3D Printer
6–20 DOC-07000 Rev. A
5. Whenthefollowingscreenappears,openthecover.
Figure 6-17: Head cleaning wizard—steps 5–10
6. Placethemirroronthebuildtray.
7. Putonthegloves.
8. Soakthecleaningclothwiththecleaningfluid.
9. Cleantheorificeplates,withaback‐and‐forthmotion(seefigure 6‐17).
Usethemirrortomakesurethatyouhaveremovedalloftheresidue
material.
Figure 6-18: Cleaning the heads
10. Whenyouhavefinishedcleaning,selecttheconfirmationcheckboxin
thewizardscreen(seefigure 6‐16)andclick
Next.
WARNING: The print head orifice plates (bottom surface) may be hot.
Do not touch them with your bare hands, and proceed with caution.
It is recommended that you use this opportunity to also clean the roller and
the UV lamps.