User's Manual

DOC-07000 Rev. A 6–11
Objet500 - Connex 3 User Guide
Changing the Model Material
Beforeproducingmodelsusingadifferenttypeofmodelmaterialthanis
currentlyinstalled,runtheMaterialReplacementWizardtoflushtheprint
blockandfeedtubes.
To replace the model material:
1. StarttheMaterialReplacementWizardfromtheOptionsmenu.
Figure 6-8: Starting the Material Replacement Wizard from the Options menu
2. Intheopeningscreen,clickNext
You should carefully plan printing models with different model materials to
avoid unnecessary waste of material currently loaded. The amount of
material flushed depends on the flushing cycle chosen and if you are
replacing one or more materials.
The Material Replacement Wizard suggests the best slot locations for
placing different material cartridges, based on materials in the system. This
ensures minimum flushing of materials currently loaded.