User's Manual

Operating & Maintaining the Objet500 - Connex 3 3D Printer
6–10 DOC-07000 Rev. A
printingstoppageonamodeldependonthemodelsizeandstructure,
modelmaterialused,ambienttemperatureandthelengthofthe
stoppage.
If you cannot continue printing:
1. CanceltheprintjobintheJobManagerscreen.
2. Removethepartiallyprintedmodelfromthebuildtray.
3. Sendthejobtotheprinteragain.
You can stop and later resume printing from either the printer interface or
from the Job Manager screen of Objet Studio, since both applications are
updated when you use these commands. However, after clicking the Pause
button in the printer interface, you can only resume printing from the printer
interface.