User Guide


Site Preparation Guide Site Prep Tasks
Page 5
Environmental Requirements
• The F120 printer can be used in any controlled environment.
• Air quality conditions with excess
ive solid particulates (conductive or non-conductive) may
result in system damage.
• Air quality conditions in which airborne oils ar
e allowed to accumulate on or within the
printer can damage the plastic components.
• System operating temperature shall be in the rang
e of 59°F to 86°F (15°C to 30°C), with
relative humidity range of 30% to 70% non-condensing.
• System storage temperature shall be in the range
of 32°F to 95°F (0°C to 35°C), with
relative humidity range of 20% to 90% non-condensing.
• Altitude shall not exceed 6561.68 feet (2000 m).
• Material storage shall be in the range of 55°F to 86°F (13°C to 30°C), with relative humidity
less than
70%.
•
Noise emission (acoustic):
• <32dBA when idle
• <46dBA when building
Heat Output
Heat dissipation occurs mostly through the top of the printer. Heat output is material dependent
due to the various temperatures maintained in the build chamber.
Material Type Heat Output (while building) Heat Output (while idle)
ABS ~2300 BTU/hr ~1800 BTU/hr
ASA ~2300 BTU/hr ~1800 BTU/hr
Power Consumption
Power consumption is material dependent due to the various temperatures maintained in the
build chamber.
Material Type
Power
Consumption
(while building)
Power Consumption
(while idle)
Power
Consumption
(while sleeping)
ABS 650 W 510 W 10 W
ASA 650 W 510 W 10 W