User Guide


Site Preparation Guide Preparing For Installation
Page 8
Unpacking and Positioning the Printer
Make sure that there is at least 70 inches (178 cm) of clearance for the printer before
you begin the process of unpacking the printer.
1. Inspect the Tilt Indicators (2) and ShockWatch indicator affixed to the exterior of the
cardboard box. If possible, take a picture of these indicators to share with your installation
representative. If damage is detected upon installation, this photo will assist your
installation representative in determining the cause of damage (
Figure 3).
Figure 3: Shipping Crate Detail (Back View)
Shipping
Bands (3)
Tilt
ShockWatch
Tape
Indicator
Indicator
Tilt
Indicator
Warning: Personal Injury Hazard
Shipping bands are very tight; when cutting shipping bands they may pop open with
force. Wear safety glasses when removing the shipping bands.
2. Carefully cut the shipping bands (3) and remove the tape (
Figure 3).