Users Manual

6WUDWDV\V --  2SHUDWLQJ DQG 0DLQWDLQLQJ WKH 3ULQWHU
'2& 5HY $ 
,PSRUWDQW
,IWKHVHDOVDUHQRWUHPRYHGZLWKWKHKHDGWKH\DUHSUREDEO\VWXFNWRWKHSULQW
EORFNKRXVLQJ,IVRUHPRYHWKHP
)LJXUH0DNLQJVXUHWKH2ULQJVDUHQRWVWXFNWRWKHSULQWEORFN
,QVWDOOLQJWKH
1HZ+HDG
17. Place four (4) O-ring seals in the replacement head (see Figure 4-90 on the
previous page).
18. Position the head in the print block, making sure that the location pins
are in place.
1RWH0DNHVXUHWRLQVHUWWKHKHDGZLWKWKHFRQWDFWVRQWKHGULYHUFDUGIDFLQJ
WKHSULQWEORFN
19. Tighten the upper and lower screws that secure the print head in the print
block (see Figure 4-89 on the previous page).
1RWH+DQGWLJKWHQWKHVHVFUHZV7RDYRLGRYHUWLJKWHQLQJGRQRWXVHDKH[
$OOHQNH\
20. Insert the driver card into its socket, and secure the card.
)LJXUH6HFXULQJWKHGULYHUFDUG
21. Lower the protective cover and tighten the screws to secure it.