Users Manual

6WUDWDV\V --  2SHUDWLQJ DQG 0DLQWDLQLQJ WKH 3ULQWHU
'2& 5HY $ 
6. Before returning the roller waste collector to the print block, make sure
that the pins are clean.
)LJXUH5ROOHUZDVWHFROOHFWRUSLQV
7RUHDVVHPEOHWKHFRPSRQHQWV
1. Return the roller waste collector to the print block and screw on the
covering (see Figure 4-46 on the previous page).
2. Loosen the screws securing the suction tube.
)LJXUH3RVLWLRQLQJWKH VXFWLRQ WXEH
3. Lower the suction tube so that the hole in the panel behind the tube is
visible, and tighten the screws to secure the tube.
4. Attach the right-UV-lamp assembly to the print block and reconnect the
UV power and fan cables.
5HSODFLQJ WKH
5ROOHU6FUDSHU
You should replace the roller scraper blade—
• after 1,000 hours of printing.
• if it does not effectively keep the roller clean.
<RX VKRXOGSHULRGLFDOO\WHVWWKH HIIHFWLYHQHVVRIWKH UROOHUVFUDSHUZKHQ \RX
FOHDQ WKHUROOHUZDVWHFROOHFWRU6HH &OHDQLQJWKH 5ROOHU:DVWH&ROOHFWRUDQG
,QVSHFWLQJWKH5ROOHU6FUDSHURQSDJH