Users Manual

6WUDWDV\V --  2SHUDWLQJ DQG 0DLQWDLQLQJ WKH 3ULQWHU
'2& 5HY $ 
3URGXFLQJ0RGHOV
Models can be printed after they are arranged on a virtual build tray in the
GrabCAD Print application. For information about preparing model files for
printing, see the GrabCAD Print online
documentation.
3UHSDULQJWKH
3ULQWHU
Before beginning to produce models, it is recommended that you check the
current printing quality of the print heads by performing a pattern test (see
"Pattern Test" on page 4-31).
7RSUHSDUHWKHSULQWHUIRUSURGXFLQJPRGHOV
1. Make sure that the build tray in the printer is empty and clean. If not,
remove cured material with the scraper, and clean the tray thoroughly
with a wet cleaning cloth.
&DXWLRQ
8VHSURWHFWLYHJORYHVZKHQFOHDQLQJWKHEXLOGWUD\DQGEHFDUHIXORIWKH
VKDUSHGJHVRIWKHVFUDSHUEODGH
2. Make sure that there is sufficient Model and Support material loaded, as
indicated on the printer interface (see the figure on page 4-4). You may
want to replace the cartridges of Model and Support material currently
loaded in the printer to avoid the need for replacing them during printing.
)RULQVWDOOLQJPDWHULDOFDUWULGJHVDQGUHSODFLQJHPSW\RQHVVHH/RDGLQJ
0RGHODQG6XSSRUW&DUWULGJHVRQWKHSUHYLRXVSDJH
)RUFKDQJLQJWKHW\SHRI0RGHOPDWHULDOFXUUHQWO\ORDGHGVHH&KDQJLQJWKH
3ULQWLQJ0DWHULDORQSDJH