Users Manual

6WUDWDV\V --  6DIHW\
'2& 5HY $ 
,QKDODWLRQ
Vapors from printing materials can be irritating to the respiratory system. If
respiratory irritation occurs, expose the victim to fresh air immediately.
➢ If the victim has stopped breathing, perform artificial respiration or
cardiopulmonary resuscitation.
➢ Seek medical attention immediately.
➢ Keep the victim warm but not hot.
➢ Never feed anything to an unconscious person.
➢ Oxygen should be administered by authorized personnel only.
:DVWH'LVSRVDO
Fully cured printed models can be disposed of as ordinary office trash.
However, special care is required when handling printer waste (uncured
printing material).
3ULQWLQJ
0DWHULDOV
➢ When removing the waste container from the printer, wear neoprene or
nitrile gloves.
➢ To prevent liquid waste from splashing into the eyes, wear safety goggles.
➢ Liquid waste from the printer is classified as hazardous industrial waste.
Therefore, printing-material waste must be packaged and disposed of in a
manner that prevents human contact with it and contamination of water
sources.
➢ Empty Model-material and Support-material cartridges contain residue of
their contents. Some leakage of this residue may occur through the broken
cartridge seal. Therefore, handle and store empty cartridges with care.
➢ Do not attempt to reuse empty cartridges, and do not puncture them.
➢ Dispose of used cartridges and waste containers in accordance with local
regulations.
➢ Discard contaminated clothing, shoes, empty containers, etc., in
accordance with any applicable regulations.
89/DPSV
UV lamps used by the printer to cure printing materials contain a small
amount of mercury, and are considered “Universal Waste.” Recycle or discard
used lamps in accordance with applicable regulations.
Broken lamps:
After ventilating the area, use protective gloves and carefully remove spilled
mercury with a method that prevents the generation of mercury vapor, such
as a syringe, packing tape or paper. Place the broken lamp, mercury and
contaminated materials in an air-tight, non-metallic container. Dispose of the
container in accordance with applicable regulations.