Users Manual

ManualsBrandsStratasys ManualsElectronicsAssembly of RFID reader and antenna boards.

120

121

122

123

124

125

126

127

128

129

6WUDWDV\V --  +DQGOLQJ 3ULQWHG 0RGHOV

'2& 5HY $ 

5HPRYLQJ

683ZLWK

&DXVWLF6RGD

Soak models in a 1-percent solution of caustic soda (sodium hydroxide) to

remove Support material from difficult-to-reach areas and to give the model a

smooth, clean finish. The amount of time you soak the model in the solution

depends on how delicate it is and how much Support material needs to be

removed, but it is typically between half-an-hour and several hours. In any

case, you should remove as much Support material as possible before the

caustic soda treatment, and rinse the model thoroughly (with a water jet)

afterwards.

:DUQLQJ

&DXVWLFVRGDPD\FDXVHFKHPLFDOEXUQVVFDUULQJDQGEOLQGQHVV0L[LQJLW

ZLWKZDWHUJHQHUDWHVKHDWWKDWFRXOGLJQLWHRWKHUPDWHULDOV1HYHUSRXUZDWHU

LQWRFDXVWLFVRGD:KHQGLOXWLQJWKHVROXWLRQDOZD\VDGGFDXVWLFVRGDWR

ZDWHU7DNHDGHTXDWHVDIHW\SUHFDXWLRQVDOZD\VXVHQLWULOHJORYHVZKHQ

KDQGOLQJFDXVWLFVRGDDQGPRGHOVVRDNHGLQLW

5HPRYLQJ

683ZLWK

&DXVWLF6RGD

DQG6RGLXP

0HWDVLOLFDWH

Soak models in a 2-percent solution of caustic soda (sodium hydroxide) and

sodim metasilicate (Na

SiO

) to remove Support material. The amount of

time you soak the model in the solution depends on how delicate it is and

how much Support material needs to be removed. Rinse the model

thoroughly under running water afterwards.

683ZLOOGLVVROYHLQWRWKHFDXVWLFVRGDDQGVRGLXPPHWDVLOLFDWHVROXWLRQ

DQGVDWXUDWHLWUHGXFLQJLWVHIIHFWLYHQHVV5HSODFHWKHVROXWLRQZKHQWKH

6XSSRUWPDWHULDOUHDFKHVRIWKHVROXWLRQDIWHUDSSUR[LPDWHO\RQHPRQWK

RIDYHUDJHXVH