User's Instructions


Stratasys Ltd.
1 Holtzman St., Science Park, P.O. Box 2496, Rehovot 7670401, Israel T:[phone] F:[phone] www.stratasys.com
2

4.2‐ThemoduletransmitterhasRFIDtransmissionprotocols
4.3‐
TheRFIDunitvoltageis5V(producedfromthemain24VDC).
4.4‐ThemoduletransmitterhasaLoopcoilantennamfr.Stratasysmodel.BRD‐03012
4.5‐Themodulartransmitterhasbeentestedinsideanaux iliarydevicethereforeitismatchingmodulelimited
approval
4.6‐ThemodulartransmitterislabeledwithFCC
IDandasitisnotvisibletotheuser,thereisanexteriorlabel
including"ContainsFCCID:YH6‐DUPCAB1"
4.7‐ThemoduletransmittercomplieswithanyapplicableRfexposurerequirements
4.8‐Themoduletransmittercompliestopara.15part15.207and15.209
4.9‐Themoduleiscompletelytuned
andtestedbeforeshipmenttothefactory.Theretheboardwherethe
moduleislocatedisscrewedinplacetotheinternalfrontpartofthehousingofthehostandconnectedtothe
hostmainboardforinputvoltagebyawiresharness.

5‐TheRFIDmoduletransmitterhas
anintegratedantennaprintedonthePCB‐16Antennas(4antennas
connectedtoeachMSCboard).
TheantennaispartoftheprintedtracesinthePCBGerberfiles.
Themoduledoesnothaveatune‐upprocedureandalltune‐upsarecontrolledatthefactory.Theproductis
completely
tunedandtestedbeforeshipment.
6‐Themoduleinstalledinsidethehostdeviceisdesignedtobeusedsothattheradiatingstructureofthe
devicemaybeusedatanydistancefromthebodyoftheuser.
7‐TheantennaisprintedonthePCB‐seepara.5above.
8‐
ThefollowinglabelshallbeattachedtotheoutersurfaceoftheHost:
“ContainsFCCID:YH6‐DUPCAB1”
9‐OperationsystemModes
Product’smainfunctionsarereadandwritedatafrom materialcontainerprotectedbyRFIDidentificationtags