User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 6–3
Alaris30 User Guide
Job Manager
Screen
Onaclientcomputer,JobManagerdisplaysthequeueofjobssentbythat
computertotheprinterserver.
Figure 6-2: Client Job Manager screen
Informationforeachofthequeuedjobsisdisplayed,includingthejob
status:
Print Queue
Print History
Status Meaning
Waiting Printingofthisjobhasnotstarted.
Building Printingofthisjobisinprogress.
Paused Printingofthisjobbegan,butwasinterruptedbythe
administratorbeforebeingcompleted.
Stopped Printingofthisjobwasterminatedbytheadministrator,
andwasputintheprintqueueagain.
Error Errorsoccurredduringtheprintingofthisjob,anditwa
s
placedintheprintqueueagain.
Editing Thisjobisnowbeingeditedin
ObjetStudio.
Previewing Theoperatorattheservercomputerisinspecti ngthe
model’sslices.
Spooling Thejobfileisbeingspooledintheprinter.
Preprocessing The3‐Dprinterisreadyingitselfforprinting:thecover
locks,printheadswarmupandareputinstarting
position,UVlampsareturnedon,build‐traylevelis
adjusted.
DRAFT 4 - July 11, 2010