User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 5–25
Alaris30 User Guide
Figure 5-32: Tray validation warning
TocanceltheBuildcommandsoyoucancorrecttheproblem,click
No.
Toprintthemodelsastheyarepositionedonthe tray,clickYes.
Figure 5-33: Constraints Settings dialog box, with color codes for problematic
model positioning
The tray file is sent to Job Manager. Objet Studio closes and Job Manager
opens, so you can monitor the progress of your trays—before, during, and
after printing.
To return to Objet Studio from Job Manager, click New Job .
DRAFT 4 - July 11, 2010