User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 7–51
Alaris30 User Guide
10. Inspectthenewlampreflector,andmakesurethatablackstripis
attachedtotheinsideofit.Ifnot,installone—onthesideofthe
reflectoropposite(notnextto)theprintblock.
Note: Extra black strips are included in the printer Start-up Kit. If
necessary, you can remove the black strip from the old reflector and install
it in the new reflector (as long as the black paint has not faded).
11. Discardtheoldreflectorandlamp.
12. InsertthenewUVlamp/reflectorunitintothehousing.
13. MakesurethattheUV‐lampcableisinplace,insidethehousing,and
thentightenthesecuringscrews.
Figure 7-78: Cable position when installing the UV lamp
14. Replacethelampcover,andtightenthesecuringscrews.
15. ReplacetheUVlampassemblyintheprinter,makingsurethatthe
cablefitsintotheslottogetherwiththesidesecuringscrew.
Figure 7-79: UV-lamp cable after replacing the assembly
16. Tightenthetwosidesecuringscrews.
17. Reconnectthepowerconnections(seefigure 7‐73).
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
DRAFT 4 - July 11, 2010