User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
About This Guide
1–2
DOC-24000 Rev. A
Using This Guide
Thisuserguideprovidesinstructionsforinstalling,operatingand
maintainingAlaris3‐Dprintingsystems.Itexplainshowtousefeatures,
andprovidespracticalexamplestoguideyouasyouusethesystem.
Thisdocumentismeanttobeusedwiththe Alaris303‐Dprinter,running
softwareversion30.2.1,andwithObjetStu
diosoftwareversion8.5.9.
Thisguideassumesthat:
• allthehardware,software,andnetworkcomponentsofyourAlaris
systemareinstalled,configured,andoperatingcorrectly.
• theoperatorhasaworkingknowledgeoftheWindows
®
PCplatform.
For More Information
Visithttp://www.objet.com/formoredetailsaboutObjet’stechnology,
productsandconsumables,andforserviceandsupportcontacts.
ForotherdocumentsthatrelatetoAlaris303‐Dprintingsystems,andfor
thisdocumentinotherlanguages,contactyourregionalObjetCustomer
Supportoffice.
Ifyouhaveanyquestionsabouttheinformationpresentedinthis
document,orifyo
uhaveanycommentsorsuggestionsforfutureeditions,
pleasesendamessagetosupport@objet.com.
DRAFT 4 - July 11, 2010