User Guide

http://onsemi.com

2. Connect the other part of 6-pin FPC cable into control board STR-DMS-CONTROL-GEVB as shown in Fig.4. Blue part of the

FPC cable must go outside of the control board. User can control up to three GazeT IR LED driver modules over 6-pin FPC cables.

Each module will have the same V_out DCDC and I_LED current and PWM flash signal.

Fig. 4: connection of the 6-pin FPC cable from GazeT LED driver module (STR-DMS-NCV7694-GEVB) into Control board

(STR-DMS-CONTROL-GEVB)

3. Make sure you have available Regulated Constant Voltage Power supply with current capability up to 5A. Connect the external

power supply and polarity per Fig.5 and set voltage to 13V (current limitation 5A min). Turn the power supply ON. With PWM

generated by Strata interface, leave PWM cable from 3-pin connector open (unconnected). You can connect and simultaneously

control up to three STR-DMS-NCV7694-GEVB over FPC cable to single STR-DMS-CONTROL-GEVB board. Supply wires should

be connected together to Regulated Voltage Source (all minus poles and all plus poles).

Fig. 5: Connection of the external power supply