Instruction Manual

Problem
Cause
Soluon
Arc spluers/ares
Water in the air supply
Install air drier or addional
ltraon.
Drain compressor and air lines.
Torch parts wear quickly
Wet or dirty air supply
Install air drier or addional
ltraon.
Drain compressor and air lines.
Exceeding unit capability
If material too thick, increase
angle to prevent blow back into
torch p
Excessive ignion Arc use
Do not operate ignion arc for
more than 3 seconds ideally
start in contact with edge of
material.
Do not start ignion arc in mid-air.
Inadequate air supply, pressure
too low
Check air lters, increase air
pressure
Faulty air compressor
Check air compressor operaon
and make sure input air pressure
is at least 100psi.
Circuit breaker/fuse trips
while operang
Extension cord being used is not
heavy duty
Use a heavy duty extension cord
(2.5mm
2
)
Extension cord being used is too
long
Remove extension cord or use
shorter one.
Please refer to Strata website www.strata.co.nz for more informaon.
27
www.strata.co.nz
ADVANCECUT 45