MSDS

®
The Armor All/STP Products Company
The Armor All/STP Products CompanyThe Armor All/STP Products Company
The Armor All/STP Products Company
39 Old Ridgebury Road
Danbury, CT 06810
Tel. [phone]
Material Safety
Material SafetyMaterial Safety
Material Safety
Data Sheet
Data SheetData Sheet
Data Sheet
I Product:
I Product:I Product:
I Product:
STP® MULTIPURPOSE MOTOR TREATMENT
Description:
Description:Description:
Description:
LIGHT COLORED LIQUID WITH A MILD ODOR
Other Designations
Other DesignationsOther Designations
Other Designations Dist
DistDist
Distributor
ributorributor
ributor Emergency Telephone Nos.
Emergency Telephone Nos.Emergency Telephone Nos.
Emergency Telephone Nos.
The Armor All/STP Products Company
39 Old Ridgebury Road
Danbury, CT 06810
For Medical Emergencies, call 1-800-446-1014.
For Transportation Emergencies, call
1-800-424-9300 (Chemtrec).
II Health Hazard Data
II Health Hazard DataII Health Hazard Data
II Health Hazard Data III Hazardou
III HazardouIII Hazardou
III Hazardous Ingredients
s Ingredientss Ingredients
s Ingredients
May cause eye irritation. May cause slight skin irritation. Prolonged skin contact may cause
dermatitis. Vapors or mists may cause irritation to the eyes, nose, throat, and respiratory tract.
High concentrations above the worker exposure limits may cause central nervous system
depression (e.g. dizziness, weakness, nausea, headaches, drowsiness and stupor). Small
amounts of liquid aspirated into the lungs can cause chemical pneumonitis, which can be fatal.
Besides being an aspiration hazard, ingestion may cause gastrointestinal disturbances (e.g.
irritation, nausea, vomiting, and diarrhea) and central nervous system depression. Repeated
overexposure to petroleum naphtha can cause nervous system damage.
Preexisting eye, skin, and respiratory disorders may be aggravated by exposure to this product.
FIRST AID:
EYE CONTACT: Rinse with water for several minutes. Remove contact lenses if present and
easy to do. Continue rinsing. If irritation persists, call a doctor.
SKIN CONTACT: Wash with soap and water. If irritation persists, call a doctor.
INGESTION: DO NOT INDUCE VOMITING. Immediately call a doctor or poison control center.
INHALATION: Move to fresh air. If breathing problems develop, call a doctor.
Ingredients Concentration Worker Exposure Limit
Petroleum naphtha, hydrotreated light 10 - 100% 1200 mg/m
3
TWA
d
CAS # 64742-47-8
Diphenylamine 0 - 10% 10 mg/m
3
TLV-TWA
a
CAS # 122-39-4
Mineral Oil 10 - 100% 5 mg/m
3
(inhalable) TLV-TWA
a
CAS # Proprietary 5 mg/m
3
PEL-TWA
b
a
TLV-TWA = ACGIH Threshold Limit Value - Time Weighted Average
b
PEL = OSHA Permissible Exposure Limit - Time Weighted Average
c
TLV-STEL = ACGIH Threshold Limit Value - Short Term Exposure Limit
d
Based on supplier recommendation.
None of the ingredients in the product are on the IARC, NTP, or OSHA carcinogen lists.
IV Special Protection and Precautions
IV Special Protection and PrecautionsIV Special Protection and Precautions
IV Special Protection and Precautions V Transportation and Regulatory Data
V Transportation and Regulatory DataV Transportation and Regulatory Data
V Transportation and Regulatory Data
Hygienic Practices: Wash hands after direct contact. Do not wear product-contaminated
clothing for prolonged periods.
Engineering Controls: Use local or general ventilation to minimize exposure to product
vapors.
Personal Protective Equipment: Wear safety glasses. Wear chemical resistant (e.g. nitrile or
neoprene) gloves if there is the potential for repeated or prolonged skin contact. In situations
where exposure limits may be exceeded, a NIOSH-approved respirator is advised.
DOT: Not regulated in non-bulk packaging (less than 119 gal).
IATA: Not regulated.
IMDG: Not regulated.
EPA - SARA Title III/CERCLA: This product is regulated under Sections 311/312. This product
is not regulated under Section 313 or Section 304/CERCLA.
TSCA 8(b): All components of this product are either on the TSCA 8(b) Inventory or otherwise
exempt from listing.
TSCA 12(b): This product is not subject to TSCA 12(b) reporting requirements.
VI Spill Procedures/Waste Disposal
VI Spill Procedures/Waste DisposalVI Spill Procedures/Waste Disposal
VI Spill Procedures/Waste Disposal VII Reactivity Data
VII Reactivity DataVII Reactivity Data
VII Reactivity Data
Spill Procedures: CAUTION – COMBUSTIBLE. Eliminate potential sources of ignition. Absorb
and containerize. Prevent product from entering sewer or waterways by diking or impounding.
Notify the National Response Center if a spill of any amount enters navigable waters, the
contiguous zone, or adjoining shorelines.
Waste Disposal: Dispose of in accordance with all applicable federal, state, and local
regulations.
Stable under normal use and storage conditions.
Avoid contact with strong oxidizing agents.
VIII Fire and Explosion Data
VIII Fire and Explosion DataVIII Fire and Explosion Data
VIII Fire and Explosion Data IX Physical Data
IX Physical DataIX Physical Data
IX Physical Data
Flashpoint: 66°C (closed cup)
Fire Extinguishing Agents: Dry chemical, carbon dioxide (CO
2
), foam, or water spray.
Specific gravity (16°C)............................................................................................................ 0.83
Solubility in water ............................................................................................................ Insoluble
DATA SUPPLIED IS FOR USE ONLY IN CONNECTION WITH OCCUPATIONAL SAFETY AND HEALTH DATE PREPARED 4/2011