user manual
RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 32
MAINTENANCE/SERVICE
FIGURE 35
5) Belt alignment is checked with the straightedge.
Place the straightedge squarely against the arbor
shaft pulley. Properly aligned pulleys should also
place the straightedge squarely against the
engine/motor pulley. Remove the straightedge and
rotate the engine/motor pulley 120 degrees.
Recheck alignment with the straightedge. Repeat
the process until the engine/motor pulley is rotated a
full 360 degrees. Maximum allowable misalignment
is + - 1/32 inch. If pulley alignment is not within
specifications, refer to INSTALLING A
REPLACEMENT V-BELT for specific information.
FIGURE 36.
FIGURE 36
6) Reinstall the belt guard to the main frame.
Determine that all safety related decals affixed to the
belt guard are fully readable. If any decal is not fully
readable, replace with a factory approved,
replacement part only.
7) Reconnect the engine spark plug wire. Position.
DANGER
UNEXPECTED MACHINE START UP CAN
RESULT IN PROPERTY DAMAGE AND/OR
PERSONAL INJURY.
INSTALLING A REPLACEMENT V-BELT OR
PULLEY.
Tools Required:
2 each, 9/16 wrenches.
1 each, 5/32 Allen wrench.
1 each, 16 inch minimum length straightedge.
1 each, 10 lbs minimum capacity, tension scale or
belt tension tool.
Parts Required:
2 each, PN BX34 V-belt (if required).
1 each, PN CS8-0260 pulley assembly (if required).
1 each, PN CS8-0270 pulley assembly (if required).
1) Position the Crack Saw on a suitable work
surface with the V-belts approximately at waist level.
2) If the Crack Saw is powered by an engine,
disconnect the spark plug wire. If powered by an
electric motor, disconnect the extension cord or
Crack Saw from the power source. If the Crack Saw
is powered with a Propane converted engine, the
Propane cylinder must be removed from the main
frame to better facilitate the maintenance process.
Determine that the Propane cylinder valve is fully
closed before uncoupling the hose. Secure in a
proper storage area. Using the 9/16 inch wrenches,
remove the belt guard from the main frame. Clean
the inside of the belt guard with an appropriate
solvent. Check for signs of wear and damage.
Secure in a proper storage area.