Operation Manual

The touch control programmer
There are three touch control icons for
this timer - the table below shows you
what the symbols look like, depending on
the model type, & their functions.
Note - some functions require you to
‘touch & hold’ an icon for a few seconds,
whilst others require you to just ‘touch’
the icon without holding.
Sym-
bol
Sym-
bol
What is it?
-
Down/minus
Used to decrease
cook / end time, re-
move minutes from
the minute minder
and adjust the time
of day. Also for lis-
tening to and setting
the alarm tone.
+
Up/plus
Used to increase
cook / end time,
add minutes to the
minute minder and
adjust the time of
day.
FUNC-
TION
MODE
Function icon
Used to select the
functions available
on this timer.
Touchoncefor:
Minute Minder.
Touchtwicefor:
Cook time
Touch three times
for:Endtime.
How to use these
functions is ex-
plained later on in
this section.
The ‘function’ icon in the centre is used for
setting the minute minder & setting up the
automatic cooking - see below for details.
Symbols on the LED display.
This ‘A’ symbol appears when either
a semi, or fully automatic program is
selected.Thissymbolwillashwhilea
program is being set.
Once a program is set the symbol will light
up, and remain lit until the alarm sounds,
or the program is cancelled.
This Bell symbol appears when the Minute
Minder function has been selected.
While the Minute Minder is being set, the
Bellsymbolashes.Oncethelengthof
time is set, the Bell symbol remains lit
until the time runs down, or the function
is cancelled.
This message and ‘A’ symbol appear when
you are asked to set the length of time
you require the oven to cook automatically
for. Using the Up and Down icons adjusts
this accordingly.
This message and ‘A’ symbol appear when
you are asked to enter in an end time, or
when you would like the oven to switch
itself off.
USING THE CLOCK/PROGRAMMER-ELEC(if fitted)