Vogue Midi T Highline Ins…lation User Instructions

8
5.2 If the appliance has been previously used rake any ash
remaining from the previous burn level in the firebox.
Approximately 25mm of ash can be left for a good base for
starting the new fire. Take care as hot embers can remain in
the fuel bed for a long time after the stove was last used.
5.3 To create an open stack for top down lighting:
1. Place two medium sized logs parallel on the base of
the firebox.
2. Place two smaller logs on top running parallel across
the bottom logs.
3. Continue to build the stack using smaller logs and
place firelighters in the centre.
4. Finish the stack by adding two further logs and placing
firelighters on top. Add extra smaller kindling if desired.
13
1
2
3
4
5.4 Light the upper firelighters. This will create a flame that will
ignite the logs/ kindling whilst warming the flue to accelerate
the flue draw, see Diagram 14.
14
4.6 If the Smoke Control kit is enabled the air control slider will be
pulled out 47mm, see Diagram 11.
11
Side View
47
4.7 To meet the requirements of a Smoke Control Area the
appliance MUST be operated correctly in order to minimise
the amount of smoke produced.
If this appliance is installed outside of a Smoke
Control Area then the Smoke Control setting can be
disabled to give more control over the lower burn
rates.
Any modifications should only be done by a
suitably qualified installer and must be done at the
time of installation.
These instructions must be left with the User.
5. Lighting the Appliance
5.1 For best results set air controls as shown, see Diagram 12.
12
Off
(Maximum Out)
Nominal Running
Smoke Control Setting
(if enabled)
Maximum Running
Start Up
(Maximum In)
Wood
Multi-fuel
Wood Maximum Running
(Maximum out)
Off / Smoke Control
Setting (If enabled)
Multi-Fuel Running
Start Up
(Maximum In)
User Instructions