Vogue Midi T Highline Ins…lation User Instructions

42
Maintenance & Servicing
7.2 Use a 13mm A/F spanner to loosen the half lock nuts either
side of the box section in the appliance body.
This will allow the dome catch to rotate in and out,
see Diagram 7.
DO NOT undo the catch more than 3-4mm.
7
Box Section
Appliance Body
Half Lock
Nuts
Dome
Catch
7.3 Ensurethedomecatchisinanuprightpositionwiththeat
sides parallel with the side of the appliance, see Diagram 8.
Dome Catch
Door Catch Slider
Side of Appliance
8
When the door closes the Dome Catch should sit centrally in
the slot of the door catch slider.
7.4 Adjust the height of the catch so that the door locking
mechanism makes contact slightly above the point of the
Dome Catch, see Diagrams 9, 10 & 11.
9
Dome
Catch
Point of
Dome
Appliance
Body
Positioning the catch
too low will not allow the
locking mechanism to
drop far enough over the
Dome to secure the door
if the metal expands in
the heat
Locking
Mechanism
Door
Casting
Incorrect Position - Dome catch too low
Dome
Catch
Point of
Dome
Appliance
Body
When the catch is in
the correct position the
locking mechanism can
slide over the Dome
and drop far enough to
secure the door
Locking
Mechanism
Correct Position
10
11
Dome
Catch
Point of
Dome
Appliance
Body
Positioning the catch
too high will not allow
the locking mechanism
to slide over the Dome
and fasten securely in
place
Locking
Mechanism
Door
Casting
Incorrect Position - Dome catch too high
7.5 Toensurearmholdbythelockingmechanism,thecatch
should be positioned to allow the maximum distance of travel
up and down over the tapered end of the catch.
Note: If the point of the Dome Catch is in line with the
bottom of the locking mechanism this will prevent the
door from being pushed closed, too high and the catch
won't travel far enough down the other side of the catch
to hold the door if the metal expands when hot.
7.6 Fully tighten the lock nuts to secure the Dome Catch.
7.7 Open and close the door several times to the check the
adjustment.
8. Final Checks
8.1 Following these adjustments check that the door:
— Does not come into contact with the log guard.
— Can be pushed shut without operating the door handle.
— Passes the paper sealing test.
— Aligns with the side and top of the appliance.