Vogue Midi T Highline Ins…lation User Instructions
34
Installation Instructions
Multi-Fuel Burning Stove
Multi-fuel appliances are supplied with an additional
DEFRA approved slide restrictor plate making them
exempt from the controls that generally apply in
Smoke Control Areas.
THIS PLATE IS SUPPLIED SEPARATELY AND
THE APPLIANCE MUST BE MODIFIED BEFORE
INSTALLATION, IN ORDER TO MEET THE
REQUIREMENTS OF A SMOKE CONTROL AREA
AND MUST BE OPERATED CORRECTLY IN ORDER
TO MINIMISE THE AMOUNT OF SMOKE PRODUCED.
If this appliance is installed outside of a Smoke Control
Area then there is no need to fit the supplied DEFRA
plate.
Any modifications to the setting should only be
done by a suitably qualified installer and must be
done at the time of installation.
This section applies to the Vogue products listed:
Product Code Appliance
VG-MIDTHLMF1-E Vogue Midi T Highline Multi-Fuel
5.6 The Vogue models listed are supplied with a smoke control
kit and have been independently tested to PD6434 making
them exempt from the controls that generally apply in Smoke
Control Areas.
5.7 These models are suitable for use in a Smoke Control Area
when burning wood and following the instructions for use
speciedinthismanualbutONLYiftheSmokeKithasbeen
tted.
5.8 Iftted,theSmokeControlkitisattachedtothefrontofthe
appliance via 4 screws, see Diagram 20.
20
This will ensure the air controls cannot be shutdown &
the appliance operates in a manner that conforms to the
emissions standards for a Smoke Control Area.
5.9 To meet the requirements of a Smoke Control Area the
appliance MUST be operated correctly in order to minimise
the amount of smoke produced.
If these models are installed outside of a Smoke
Control Area then fitting the smoke control kit is not
necessary.
Fitting the smoke control kit should only be done
by a suitably qualified installer and must be done at
the time of installation.
5.10 MODIFICATION WILL NEED TO BE CARRIED OUT
PRIOR TO INSTALLATION OF THE APPLIANCE.
To access the air control slider, carefully tip the appliance
onto its back.
5.11 To fit the Smoke Control kit:
5.12 Loosen the M8 nut and screw, see Diagram 21.
21
5.13 Remove the 2 M8 screws and place to one side with the
spacers, see Diagram 22.
22
The air slider can be removed from the appliance.