Vogue Midi T Highline Ins…lation User Instructions

32
Installation Instructions
4.4 In order to gain access to the blanking plate, the rear heat
shield will need to be removed.
To do this:
— Remove the 4 screws on the rear of the heat shield,
see Diagram 13.
13
Knockout
Screws
Screws
 —Onceremoved,knockouttherearueblankontheheat
shield to allow the collar to pass through.
— Place the heat shield carefully to one side.
NOTE: The Data badge must be retted to the heat
shield once installation is complete.
4.5 Remove the blanking plate using a 13mm A/F Spanner/
Socket wrench to take off the 4 M8 half nuts from the outside
of the back plate of the appliance.
Remove the blanking plate from the rear of the back plate
leaving the 4 studs in place.
4.6 Fittingtheuecollarandblankingplatesforrearue:
— Fit the blanking plate removed from the rear outlet and the
 additionalblankingplatesupplied,tothetopueoutlet
using the 4 M8 nuts and bolts.
 —Sealtothereboxusingrecementandtheatgasket
provided.
 —Slidetherearuecollarontothefourstudsontheoutside
of the supplied back plate and secure using 4 x M8 nuts
and washers.
 —Sealtothereboxusingrecementandtheatgasket
provided.
— Re-install 2 upper rear bricks.
 —Re-installthebafe.
— Re-install the rear heat shield.
14
Cast Top Plate
Blanking Plates
Flue
Collar
Heat
Shield
15
Blanking Plate
Blanking Plate
Flat Gaskets
Flue
Collar
M8 Nuts
M8 Nuts &
Washers
M8 Nuts
4.7 Thefollowinguepipeisavailabletoensuresafeinstallation:
5" Tee Stovax Product Code 4516
5" 135
o
Bend Stovax Product Code 4512
5" Flue Pipe x 612mm long Stovax Product Code 4501
16
Tee with cap
Cap
Sealcollarwithre
cement
Self-tapping
screw
( 1 side only )