Vogue Installation User Instructions
29
Maintenance & Servicing
3. Fitting a new Door Glass
3.1 To maintain the safe use of your appliance you may need to
replace a damaged door glass.
3.2 Using the appliance with a damaged door glass could cause
dangerous fumes to enter the room, or the appliance to
over-fire, resulting in damage.
To do this:
3.3 Remove the round door rope.
3.4 Remove the 4 glass clips that the door rope was sat in, by
unscrewing the screws around the edge.
3.5 The glass can be lifted out and replaced.
3.6 Take note of the roping around the edge of the door glass
around the edge. This will also need replacing.
4. Fitting a new Door Seal
To maintain the safe use of the appliance damaged or worn
door sealing rope must be replaced.
NOTE: Some discolouration and flattening of the seal will
occur in normal use and this does not indicate a damaged
seal.
To do this:
4.1 Remove the door from the appliance, by opening the door
and lifting the door free of the hinge blocks on the left hand
side of the door.
4.2 Lay the door face down on a soft flat surface, to protect the
paintwork and glass.
4.3 Remove the old rope and scrape old glue from the locating
groove.
4.4 Clean the locating groove with a clean dry cloth to remove
all old dust and debris.
4.5 Squeeze a generous bead of fresh Stovax Thermic Seal
glue into the rope locating groove.
4.6 Press the new Stovax rope into the locating groove, placing
the joint in the middle of the lower edge of the door,
see Diagram 1.
Rope
Channel
Ø13mm Door
Sealing Rope
Rope joint
1
4.7 Refit the door and close the door to apply pressure to the
new rope.
4.8 Leave the door(s) closed for at least 12 hours before
lighting the appliance and run at a low temperature for
approximately one day. This allows the adhesive to fully
bond to the seal.
4.9 Using the appliance with a damaged door seal can cause
dangerous fumes to enter the room, or the appliance to over
fire, resulting in damage.
5. Adjusting the Door Hinges
5.1 To maintain the safe use of your appliance, you may need to
adjust the door hinges to ensure the door closes safely and
correctly.
The door can be adjusted in 2 different places:
5a Door Hinge Pin Assembly.
5b Hinge Blocks on Firebox.
5a. Door Hinge Pin Assembly
To adjust the Door Hinge pin assembly:
5a.1 Remove the door from the appliance, by opening the door
and lifting the door free of the hinge blocks on the left hand
side of the door.
5a.2 Lay the door face down on a soft flat surface, to protect the
paintwork and glass.
5a.3 Use the hinge pin assembly on the back of the door to
adjust the position of the door in relation to the appliance.
Hinge pin
Assembly
Socket Head
Screws x4
2
5a.4 Use a 5mm Hex Key to loosen the 4 socket head screws.
The hinge pin assembly is slotted so it can be adjusted up
or down and sideways approximately 3mm.
5a.5 Once the desired position has been achieved ensure the
dome nuts are firmly tightened against the hinge block
assembly to maintain the position.