Vogue Installation User Instructions

24
Installation Instructions
4.3 Remove the levelling feet from the front of the appliance
base.
16
4.4 The plinth front is removable. It is advisable to remove this
before fitting the appliance to the plinth.
Lift the plinth front so that the cast panel clears the 2 slots
on the plinth to remove, see Diagram 17.
Door Cast Panel
Plinth Slots
17
Standard Plinth shown
4.5 Lift the appliance onto the plinth:
— Line up the 2 side plinth braces with the 4 plinth
spacers (two each side) on the inside of the appliance.
Standard Plinth shown
Side plinth
braces
Plinth brace
Front View
Rear View
Plinth spacers
18
Ensure the sides and front of the appliance are sitting level
and flush with the plinth.
4.6 Fix the appliance to the plinth using the 2 M8 screws and 2
M8 washers provided.
M8 screw &
Washer
M8 screw &
Washer
19
Standard Plinth shown
4.7 Locate the cast panel in the 2 fixing slots to fit the plinth
front, see Diagram 19.
Plinth Slots
20
Standard Plinth shown
6. Smoke Control Kit
This appliance is supplied with a pre-tted smoke
control kit and has been independently tested to
PD6434 making it exempt from the controls that
generally apply in Smoke Control Areas.
THE SMOKE CONTROL KIT IS SUPPLIED DISABLED
AND MUST THEREFORE BE MODIFIED BEFORE
INSTALLATION, IN ORDER FOR THE APPLIANCE
TO MEET THE REQUIREMENTS OF A SMOKE
CONTROL AREA AND MUST BE OPERATED
CORRECTLY IN ORDER TO MINIMISE THE AMOUNT
OF SMOKE PRODUCED.
If this appliance is installed outside of a Smoke Control
Area then the Smoke Control kit can be left disabled to
give more control over the lower burn rates.
Any modifications to the kit should only be done by
a suitably qualified installer and must be done at
the time of installation.
6.1 This appliance is suitable for use in a Smoke Control
Area when burning wood and following the instructions
for use specified in this manual but ONLY if the Smoke
Control kit has been enabled.