Vogue Wall Mounting Kit Installation Instructions

Installation Instructions

3.5 Using a 15mm Socket Wrench secure the 5 supplied masonry

bolts in the marked positions, see Diagrams 20 & 21. Apply a

light amount of pressure when fastening to the wall.

3.6 The bolts effective length must be a minimum of 40mm. If

this is not achievable with the bolts supplied, longer masonry

bolts must be used.

Important: Apply a maximum tightening torque of

40Nm to all bolts.

15mm

ø8mm

40mm

75mm

3.7 Once the bolt is seated against the wall bracket and is rmly

secured, tighten no more than a 1/4 turn. If resistance is felt

causing excessive torque, partially unscrew the bolt then

retry.

Ensure the wall bracket is level before tightening.

NOTE: If a plinth is to be tted, this must be done

BEFORE tting the back bracket to the appliance,

see Section 1.

3.8 Remove the Blanking Plate from the rear of the appliance,

see Diagram 22.

3.9 Place the Back Bracket in position on the rear of the

appliance, see Diagram 23.