Vogue Wall Mounting Kit Installation Instructions

2b.7 Fasten the Cast Panel to the plinth using the 4 M6 screws

and washers previously removed, see Diagram 17.

NOTE: Fix through the upper slots on the brackets, and the

lower slots of the plinth, see Diagram 16.

Plinth Cross Section

Screw

Washer

Screw

Washer

The Midline Plinth installation is complete.

To fix the appliance to the wall, see Section 3.

Installation Instructions

3. Securing the appliance to the wall

3.1 Position the wall mounting bracket in the required location.

3.2 Mark the hole positions on the wall using the bracket as a

template.

Ensure that the upper edge of the bracket is horizontal and

the arrow is pointing up.

If possible, prioritise the outer most xing points in each

corner position, see Diagram 18.

NOTE: Fixing points must NOT be located in mortar, only x

into brick.

NOTE: To position the top of the wall bracket

measure the distance from the oor level and

using a spirit level draw a line 30mm lower than the

intended position of the top of the appliance.

IMPORTANT: Ensure bolts are tightly secured.

3.3 Drill the xing positions marked at ø8mm x 75mm deep (see

Diagram 21), ensuring that the holes are perpendicular to the

wall.

Vacuum any debris and excess material from the holes.

3.4 Remove the knockout from the bracket If installing a rear ue

appliance, see Diagram 19.

Remove