Studio Freestanding Installation User Instructions

20
Pre-Installation Instructions
4. Removal of the Top Baffles
The appliance is fitted with baffles in the top of the firebox to
maintain efficient combustion.
Studio 500 and Studio 1 have 1 baffle.
Studio 2 has 2 baffles.
Studio 3 has 3 baffles.
4.1 Once the loose internal components have been removed it
is possible to remove the metal Top Baffles.
Allow the appliance to cool fully before removing the baffle
system.
Studio 500 & Studio 1
Studio 500 & 1
4
These models have a single section baffle.
Studio 2
Studio 2
5
The Studio 2 baffle comes in two sections. To remove the
baffle system first disengage the left hand side. The method
of removal is the same for both sections.
Studio 3
Studio 3
6
The Studio 3 baffle comes in three sections. To remove the
baffle system the baffles must be taken out in the following
order:
Left hand side
Middle
Right Hand side
The method of removal is the same for all sections.
All Models
4.2 Use two hands and lift the front edge of the baffle to clear
the support tabs at the front of the firebox.
Push the baffle towards the back of the appliance to free it
from the tabs at the front, see Diagram 7.
4.3 Lower the baffle into the firebox to disengage from the
support pins and carefully withdraw through the front of the
appliance, see Diagram 7.
Take care not to damage the firebricks.
7
Support Pins
Tabs
1. Push Up
2. Push Back
3. Lower
4.4 If the appliance has more than one baffle remove in the
correct order.
4.5 Replace in reverse order.
4.6 The baffle system is designed to give safe and efficient
operation of the appliance. Replace damaged baffles
immediately.
4.7 Do not modify the baffle system.
Do not operate with the baffle system removed.