Studio Freestanding Installation User Instructions

19
1. General
1.1 To make the installation of the appliance easier it is best
to remove the internal components before fitting into the
builders opening/studwork.
1.2 For the best results removing the following components as
set out below.
2. Removal of the Door
Studio 500, 1 & 2
Before removing the door it is recommended to protect the
left edge from damage using masking tape.
2.1 Open the door approximately 90˚, see Diagram 1.
90˚
Hinge block
1
2.2 Move the Air Control to the far right, see Diagram 2.
45˚
Air Control
handle
2
2.3 Lift the door vertically to remove from the hinge block,
see Diagram 1.
2.4 Closethedoor45˚,ensuringtheAirControlhandlesits
inside the channel in the top of the door (see Diagram 2) and
carefully manoeuvre the door clear of the hinge mechanism.
2.5 Lie the door face down on a soft flat surface to protect the
paint work and glass.
2.6 Reverse the procedure to re-fit the door.
Studio 3
This will require 2 people.
2.7 Open the door fully (see User Instructions, page 5).
2.8 Lock the hinges in position using a ø3mm pin as shown in
Diagram 3.
ø3mm pin in each hinge
3
2.9 Raise the door vertically at the front.
2.10 Lower the door approximately 5mm and pull away from the
appliance.
2.11 Lie the door face down on a soft flat surface to protect the
paint work and glass.
2.12 Reverse the procedure to refit the door.
3. Removal of Internal Components
In the firebox of the Studio are several loose items including:
• A box containing:
Baffle Bricks
Firebricks
Bag containing Instruction Manual, Warranty & Door Tool,
Log Guard End Supports
• Log Guard
• Front Baffle Support
3.1 Remove these carefully and put them safely to one side.
They can be fitted after the appliance has been installed,
see Installation Section.
Pre-Installation Instructions