Studio Freestanding Installation User Instructions

Primary Air

Gap between Inner

and Outer box

Door

Primary Air

Restrictor

5.4 To meet the requirements of a Smoke Control Area the

appliance MUST be operated correctly in order to minimise

the amount of smoke produced.

If these Studio models are installed outside of a

Smoke Control Area then the Smoke Control kit can

be removed to give more control over the lower

burn rates.

Removing the kit should only be done by a suitably

qualified installer and must be done at the time of

installation.

These instructions must be left with the User.

6. Optional Extras

Decorative Flue Cover

6.1 This appliance can be fitted with an optional decorative

flue cover. For installation procedures please refer to the

instructions supplied with the kit - Stovax part no. PM504.

Outside Air Kit

6.2 This appliance can be fitted with an optional kit to help

bring air directly into the appliance from outside. The For

installation and operating procedures you must refer to the

instructions supplied with the Outside Air kit.

Bench

6.3 This appliance can be fitted with a bench, various sizes

are available. This must be done at the time of installation.

Please refer to instructions - PM205.

Heat Shield

6.4 This appliance can be fitted with a heat shield in order to

decrease the distance the appliance can be installed from

a wall. This must be done at the time of installation. Please

refer to instructions - PM732.

Glass Top Plate

6.5 This appliance can be fitted with a decorative glass top

plate. This must be done at the time of installation. See

installation instructions, Section 6.

Installation Checklist