Studio Freestanding Installation User Instructions

34
5a.5 To move Door Catch out:
Loosen Nuts 1 & 2.
Wind screw OUT until the Door Catch is in desired position.
Tighten Nuts 1 & 2 down to Catch Block.
8
View from above Appliance door
Move
Away from
Appliance
Catch
Catch Block
Nut 1:
Wind In
Nut 2:
Wind In
Screw:
Wind Out
Do a Paper Test
To do a paper test shut a piece of paper in the door at the
edges to test how well the rope seal stops the air from
entering the appliance. If the paper can be pulled out easily
then the seal is not sufficient and the rope must be replaced.
Repeat this around all the edges of the appliance.
5B. Adjusting the Door Catch
- Studio 3
5b.1 There is no user adjustment of the door.
6. Removal of the Firebricks
Depending on the model purchased it may be necessary to
remove additional parts of the appliance when servicing to
access the firebricks.
Studio 500 & 1
It is possible to remove the firebricks with the Upper Metal
Baffle in place.
Remove the following:
Log Guard
- Slide the Log Guard to one side to disengage from the
hole in the side brick.
- Raise the free end and remove from the gaps in the base
bricks.
- Withdraw from the hole in the other side brick and rotate
the Log Guard through the front of the appliance.
Maintenance & Servicing
Baffle Bricks
Pull the Front Baffle Support off the baffle bricks and move
as far forward as possible.
Carefully remove the bricks working from the centre
outwards.
Angle the Front Baffle Support to free from the firebox.
It is now possible to remove the Firebricks.
Lift the side bricks using the Log Guard support slots as
finger holds and clear the base bricks; angle the bottom of
the side brick towards centre of the firebox and withdraw.
Remove the back bricks, then the base bricks.
Studio 2 & 3
It is necessary to remove the Baffle Bricks and the side
Upper Metal Baffles before attempting to remove the
firebricks to avoid damage, see Pre-Installation Section.
Lift the side bricks slightly using the Log Guard support slots
as finger holds; tilt the top of the side brick towards centre
of the firebox and continue lifting to withdraw.
Remove the back bricks, then the base bricks.