Studio Freestanding Installation User Instructions

32
Maintenance & Servicing
3. Fitting a new Door Seal - All Models
Joint at Bottom
Handy rope pack
1
3.1 To maintain the safe use of your appliance you need to replace
damaged or worn door sealing rope. To complete this operation
remove the door see Section 2 in the Pre-Installation section.
3.2 Remove the old rope and scrape old glue from the locating
groove. Clean the locating groove with a clean dry cloth to
remove all old dust and debris.
3.3 Squeeze a generous bead of fresh Stovax Thermic Seal
glue into the rope locating groove.
Press the new Stovax rope into the locating groove, placing
the joint in the middle of the top edge of the door using tape
supplied for the ends.
3.4 Refit the door and close the door to apply pressure to the
new rope.
Leave the appliance closed for at least 12 hours before
lighting the appliance and using at a low output for
approximately one day.
3.5 Using the appliance with a damaged door seal can cause
dangerous fumes to enter the room, or the appliance to over
fire, resulting in damage.
4A. Adjusting Door Hinges
- Studio 500, 1 & 2
4a.1 To maintain the safe use of your appliance, you may need
to adjust the door hinges to ensure the safe, correct closing
of the door. The door must be horizontal/level with the top of
the inner box and the door catch engages correctly.
4a.2 Adjustment is possible in 2 places:
Door Hinge Assembly
Hinge Blocks on Inner Box
4a.3 Open the door to give access to these 2 positions.
Door Hinge Assembly
4a.4 Use a 10mm socket to slightly loosen the fixing nuts on the
Door Hinge Assembly, see Diagram 2.
2
Fixing Nuts x 4
4a.5 Loosening the Door Hinge Assembly allows for fine vertical
and horizontal adjustment of the door position. This may
require a trial and error approach to find the correct position.
Ensure the door is horizontal before tightening the fixing nuts.
Hinge Blocks on Inner Box
4a.6 Using a 10mm A/F spanner slightly loosen the fixing nuts
inside the stove as shown in Diagram 3.
This will give vertical and horizontal adjustment which may
need a trial and error approach to find the correct position.
The door must be horizontally level.
Screws x 4
Fixing nuts x 4
3