Studio Freestanding Installation User Instructions

27
5. Smoke Control Kit
This section applies to the Studio products listed:
Product Code Appliance
RVFST-500 Studio Freestanding 500
RVFST-1HT Studio Freestanding 1
RVFST-2HT Studio Freestanding 2
5.1 TheStudiomodelslistedaresuppliedwithapre-ttedsmoke
control kit and have been independently tested to PD6434
making them exempt from the controls that generally apply in
Smoke Control Areas.
5.2 These models are suitable for use in a Smoke Control Area
when burning wood and following the instructions for use
speciedinthismanualbutONLYiftheSmokeKithasnot
been removed.
If these Studio models are installed outside of a
Smoke Control Area then the Smoke Control kit can
be removed to give more control over the lower
burn rates.
Removing the kit should only be done by a suitably
qualified installer and must be done at the time of
installation.
The kit consists of two restricting brackets that are fitted to
each of the air controls.
5.3 To remove the Smoke Control kit first ensure the appliance
is completely cool.
5.4 Carefully follow the instructions to remove the inner box and
place on a soft flat surface it will now be possible to access
the brackets.
Airwash Restrictor
5.5 The Airwash restrictor bracket is a stop that fits on the top
left hand side of the inner box, see Diagram 20.
20
Airwash
Slider
Lower
Screws
Airwash
Restrictor
Bracket
5.6 Remove the 2 lower screws that secure the bracket to the
inner box.
The bracket can now be stored safely in case it is required.
5.7 Replace the 2 screws in the holes that are in the side of the
inner box to seal off unwanted air flow.
Primary Air Restrictor
5.8 Gently tip the inner box onto its back.
It is now possible to access the Primary Air Bracket.
5.9 The Primary Air Restrictor is secured by two screws, see
Diagram 21.
21
Primary
Air Slider
Screws
Primary Air
Restrictor
Bracket
5.10 Undo the screws by 3-4mm, but do not remove fully or the
handle will fall off.
5.11 Slide the bracket from under the screws and store carefully
in case it is required.
5.12 Tighten the 2 screws fully back into the side of the Primary
Air Slider.
6. Glass Top Plates
This appliance can be fitted with optional glass top plates.
Product Code Left Side Right Side
RVFS-500BG RVFS-MEC9298 RVFS-MEC9299
RVFS-1GB RVFS-MEC8816 RVFS-MEC8815
RVFS-2GB RVFS-MEC8808 RVFS-MEC8807
RFVS-3GB RVFS-MEC9364 RVFS-MEC9365
6.1 The glass top plates have 4 x 6mm silicon feet on the
underside to space them off the top of the appliance.
Feet
22
Installation Instructions