Studio Freestanding Installation User Instructions

26
Lower Baffle bricks
The appliance is fitted with baffles in the top of the firebox to
maintain efficient combustion.
4.12 To fit the Lower Baffle Bricks feed the Front Baffle Support
bar into the appliance and rest on top of the side bricks.
This is best done by feeding one end of the bar towards the
back of the firebox at an angle and then inserting the other end.
4.13 Once the support bar is inside the firebox bring forward as
far as possible and place on the side bricks with the solid
edge facing forward.
4.14 Insert the baffle bricks (see table) ensuring they are in the
correct orientation, see Diagram 17.
17
Rear Support Bar
Front Baffle Support
Baffle Bricks
Model Baffle Number
Studio 500 2
Studio 1 3
Studio 2 3
Studio 3 4
4.15 To do this:
— Rest the rear edge of the bricks on the support bar at the
back of the firebox.
— Fit the two side bricks first, then insert the middle brick
and support.
— Fit the Front Baffle Support over the front edge of the
baffle bricks to hold in place.
— The Front Baffle Support bar should rest in the notch on
the top of the firebricks.
Do not modify baffle bricks.
Do not operate with baffle bricks removed.
Log Guard
4.16 Ensure that the side supports have been fitted at the same
time as the side Firebricks.
To fit the Log guard:
— Insert the Log Guard through the front of the appliance at
an angle and rotate.
— With one end raised place the other end into one of the
holes in the side bricks.
— Lower the Log Guard and insert the supports into
the gaps between the base bricks and into the retaining
brackets, see Diagram 18.
18
— Slide the Log Guard across so both end locate evenly in
the holes in the side bricks, see Diagram 19.
19
Do not use appliance without the log guard in position.
Installation Instructions