Studio Freestanding Installation User Instructions

25
Installation Instructions
4.7 Removal is the reverse of this procedure.
Allow the appliance to cool fully before removing baffle
system.
Do not modify firebricks.
Do not operate with firebricks removed.
Upper Metal Baffle
The appliance is fitted with baffles in the top of the firebox to
maintain efficient combustion.
Studio 500 and Studio 1 have 1 baffle.
Studio 2 has 2 baffles.
Studio 3 has 3 baffles.
4.8 Once the firebricks have been fitted it is possible to install
the metal Top Baffles.
Studio 500 & Studio 1
Studio 500 & 1
13
These models have a single section baffle.
Studio 2
Studio 2
14
The Studio 2 baffle comes in two sections. Fit the right hand
side baffle first. The method is the same for both sections.
Studio 3
Studio 3
15
The Studio 3 baffle comes in three sections. To fit the baffle
system the baffles must be placed in the firebox in the
following order:
Right Hand side
Middle
Left hand side
The method of fitting is the same for all sections.
All Models
4.9 Use two hands and place the rear edge of the baffle over
the support pins at the back of the firebox.
Raise the front so it is level and pull the baffle forwards to
the front of the appliance and locate the keyslots in the front
lip over the tabs at the top of the inner box, see Diagram 16.
16
Support Pins
Tabs
Baffle
4.10 The baffle system is designed to give safe and efficient
operation of the stove. Replace damaged baffles
immediately.
4.11 Do not modify the baffle system.
Do not operate with the baffle system removed.